Skip to content
English
Contact us
  • There are no suggestions because the search field is empty.

How to prepare your Expandable for use.

In this article you find detailed steps to prepare your Expandable for use.

Learn how to setup your Expandable
  1. Turn the main switch to the “ON” position.
  2. Pull up the green button to release the pressure in the bellows.
  3. Briefly deactivate the parking brake from the tractor cab and then reactivate it.
  4. Press the buttons with the downward arrow simultaneously to extend the piston rods of the lift cylinders and disconnect.
  5. Tilt the side shields upward on both sides.
  6. On both sides, pull the lock of the tandem set outwards and turn it clockwise to unlock the tandem set.
  7. Unlock the slide with the control panel on both sides using the key and pull it outwards.
  8. Press the on/off switch to start control panel.
  9. Press the indicated button and slide the right segment out until the outer side is level with the side shield.
  10. Press the indicated button and slide the left segment out until the outer side is level with the side shield.
  11. Press the indicated button and fully extend the rear right lift cylinder.
  12. Press the indicated button and fully extend the rear left lift cylinder.
  13. Press the indicated buttons to hang the wheels 5 cm off the ground.
  14. Press the indicated button to move the tandem set backwards to locking point.
  15. Visually check and make sure the bumper is locked on both sides to the tandem set.
  16. Unlock the bumper on both sides.
  17. Hold the indicated button until the movement of the tandem set stops automatically.
  18. Press the indicated button until the “Touchdown” just touches the ground. Release the button immediately.
  19. Press the indicated button (“AUTO LEVEL”) so that the “Touchdown” levels itself in two directions.
  20. Press the indicated button to extend the right segment.
  21. Press the indicated button to extend the left segment.
  22. Unroll the tarp at the rear using the crank and hook the tarp at the bottom into the tandem set.
  23. Slide the control panels in on both sides and then close the flaps with the key.
  24. Tilt the two floor panels at the rear downwards.
  25. Tilt the two floor panels at the front downwards.